Pukkr Draught Excluders | Set of 2 | Grey Microfibre | 84x5x5cm Each | Door Bottom Window Sill Floor Gap | No Assembly | Energy-Saving Heat Retention | 2-Year Warranty

A Set of 2 Grey Microfibre Draught Excluders — 84x5x5cm Each, Place at Door Bottoms, Window Sills or Floor Gaps, No Assembly Required, Blocks Cold Air and Retains Heat, Energy-Saving, 2-Year Warranty

Stop cold air entering through door bottoms, window sills and floor-level gaps with this set of 2 grey microfibre draught excluders, each 84cm long, 5cm wide and 5cm tall. The 84cm length covers most standard UK interior and exterior door widths and most window sill lengths without cutting or trimming. No assembly is required — unpack and place the excluder against the gap. By blocking the cold air channel at the point of entry, the excluder reduces the rate at which heated room air escapes and cold outside air enters, which means the room reaches and holds its target temperature more quickly and a heating system does not need to run as long or as frequently to compensate for heat lost through the gap. Set includes 2 excluders, allowing both a door bottom and a window sill to be covered simultaneously, or two separate rooms to be treated at the same time. 2-year manufacturer warranty. Item Ref: 458096.

Why You’ll Love It

• 84cm length covers most standard UK door widths and window sill lengths without cutting — The draught excluder’s 84cm length fits across the bottom of most standard UK interior doors (typically 76–83cm wide) and most single window sill spans without needing to be cut, folded or modified — a draught excluder that is shorter than the door or window gap it is placed across will leave exposed sections at either end where cold air can still pass freely, reducing its effectiveness, whereas the 84cm length provides full coverage of the gap in most standard residential door and window configurations.
• 5cm height blocks the gap between door bottom and floor without impeding normal door operation — The draught excluder’s 5cm profile sits in the gap between the door bottom and the floor surface, filling the cold air channel that forms when a door does not seal flush with the floor — a gap that is particularly common with older UK doors that have settled or warped over time, or on doors fitted with hard flooring where the floor height is lower than the original carpet the door was fitted over, and where even a 1–2cm gap at floor level allows a significant volume of cold air to pass under the door throughout the day and overnight.
• Set of 2 allows simultaneous treatment of a door bottom and a window sill or two separate rooms — The draught excluder set’s 2 units allow the two most common domestic cold air entry points — the door bottom and the window sill — to be addressed at the same time in a single room, or for two separate cold rooms in the home to each receive one excluder — useful in older UK homes where multiple rooms have draughty doors or poorly sealed windows and a single excluder would require moving between rooms depending on which room is being heated at any given time.

Specification

Material: Microfibre | Colour: Grey | Size per excluder: 84L x 5W x 5H cm | Set contents: 2 x Draught Excluders | Assembly: None required | Suitable for: Door bottoms, window sills, floor gaps | Warranty: 2 years (manufacturer) | Item Ref: 458096

Package Includes

2 x Draught Excluder

Note: Each excluder measures 84cm long — measure your door or window gap before purchasing to confirm coverage. The excluder is designed to be placed against the gap and is not adhesively fixed — it may move if the door is opened forcefully or frequently. For best results on a door bottom, position centrally across the full width of the gap. Not suitable for outdoor use. Keep dry.